Add numeric suffix to filename: Adds a number to the name in case there already is a file with the same name in the directory.Directory: The directory to store the file.For example, 3mm piece of material with 3 passes might use 1mm per pass to cut all the way through. Pass Depth: This will move Z axis down by this amount for each pass.Passes: If cutting, this will repeat the entire path by the number of passes.Delay in ms for 3D printers and seconds for GRBL. It is used to heat up the material and initiate the burning process. Power On Delay: This will turn on the laser and wait to move until the delay is complete.If you don’t have PWM, keep at max power (either 255 or 12000). For GRBL 0.9 and 1 standard, use a number between 0 (12000 being full power). For J Tech firmware and most 3D printers use a number between 0 and 255 (255 being full power).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |